To Next PageTo Next PageWhat to do if my MX-PG Inverter has no electrical output?
If there is no electrical output from your MX-PG Inverter, first check if the overload protection switch in the AC power generator has been released. If it has, reactivate the protection switch.
How to troubleshoot a MX-PG Inverter when the motor does not start?
If the motor of your MX-PG Inverter doesn't start, consider these possible causes and solutions: * The fuel tank may be empty. Fill it with fresh fuel. * The fuel valve might be closed. Turn it to the 'ON' position. * The motor oil level could be too low (oil warning lamp flickering). Refill the motor oil. * The On/Off switch may be in the wrong position. Switch it to the correct position. * The ignition plug or air filter might be dirty. Clean or replace them.
Why is my MX-PG Inverter motor noisy and running irregularly?
If your MX-PG Inverter's motor is running noisy and irregular, it could be due to several reasons: * A dirty ignition plug. Try cleaning or replacing it. * A dirty air filter. Clean or replace the air filter. * Contaminated or old fuel. Replace the fuel. * The choke is switched to 'CHOKE'. Turn the choke switch to 'RUN'. * Using the wrong fuel, such as diesel instead of petrol. Replace the fuel with the correct one.
General| Model | PG 3010F |
|---|---|
| Input Voltage | 12V DC |
| Output Frequency | 50 Hz |
| Continuous Power | 3000W |
| Peak Power | 6000W |
| Cooling | Fan |
| Efficiency | 90% |
| Protection | Overload, Short Circuit |
| Operating Temperature | -10°C - +50°C |
Never operate the appliance inside buildings or without proper ventilation due to toxic exhaust gases.
Procedure for checking the motor oil level before starting the engine.
Instructions on how to safely refuel the generator with appropriate fuel.
Guidance on connecting the generator to a grounding source for safety.
Step-by-step instructions for starting the generator motor.
Instructions for stopping the motor during normal operation and in emergencies.
Detailed steps for draining and refilling the motor oil.
Common causes and solutions for the motor not starting.
Troubleshooting steps for an unstable engine running.
