2200Q2JE-HO-KHM-N_2015.02.
Chapter 1 Safety
Ammonia Semi-hermetic Motor with K-series Compressor 1.3 Residual Risks
1-5
Table 1-2 Hazardous Sources (continued)
Hazardous Area Predicted Hazard
Actions to Take During
Operation
Actions to take During
Cleaning, Inspection, or
Parts Replacement
F Discharge (side)
Stop Valve
Discharge Piping of
compressor
Contact with or
inhalation of
hazardous material
Burn
Wearing a personal
protection gear
Sufficient ventilation
Installation of a
guard or other
protection
Do not touch with
bare hands directly
Wearing a personal
protection gear
Sufficient ventilation
Perform the work only
when the temperature
is 40°C or less
G Gas Purge Valve of
compressor
Contact with or
inhalation of
hazardous material
Wearing a personal
protection gear
Sufficient ventilation
Wearing a personal
protection gear
Sufficient ventilation
H Oil Drain Burn
Contact with
hazardous material
Do not touch while
in operation
Wearing a personal
protection gear
Perform the work only
when the temperature
is 40°C or less
I Motor Getting a burn by
touching it when it
is hot
Electric shock
Do not touch with
bare hands
directly
Wearing a
personal
protection gear
Lock-out/tag-out for
the motor main
power and control
power
Wearing a personal
protection gear
Perform the work
only when the
temperature is 40°C
or less
J Noise Hearing impairment
due to loud noise
Wearing a personal
protection gear
—
For dangerous parts of the compressor, also refer to the illustration in the section 1.3 in "Reciprocating
Compressor K-series instruction manual".
For the potential risk of electric shock due to the motor, a warning label is attached to this product.
Refer to Figure 1-1 "Warning label pasting position" in the following page.
To Next Page
Loading...