mycom K Series - Chapter 1 Safety; Strict Requirements and Prohibitions

To Next Page

To Previous Page

2200Q2JE-HO-KHM-N_2015.02.

Table of Contents

Ammonia Semi-hermetic Motor with K-series Compressor

Table of Contents

Preface .......................................................................................................................... i

Revision history ...................................................................................................... i

Warranty and Disclaimer ............................................................................................. ii

Warranty ................................................................................................................ ii

Disclaimer of Warranty .......................................................................................... ii

Important Information ................................................................................................. iii

Intended Use of this Product ................................................................................ iv

Precautions for the Safe Use of this Product ........................................................ iv

About this Manual .................................................................................................. v

Structure of this Manual ......................................................................................... v

Table of Contents ........................................................................................................ vi

Chapter 1 Safety

1.1 Strict Requirements and Prohibitions ........................................................ 1-1

1.1.1 Strict Requirements (Do’s) .................................................................................. 1-1

1.1.1.1 General ........................................................................................................ 1-1

1.1.1.2 Do’s on Operation ....................................................................................... 1-1

1.1.1.3 Do’s on Maintenance................................................................................... 1-1

1.1.1.4 Do’s on Lock-out/Tag-out Procedures after Power is Off ............................ 1-2

1.1.1.5 Do’s on Personal Protective Gear ............................................................... 1-2

1.1.1.6 Do’s in Handling of Hazardous and Toxic Substances ............................... 1-2

1.1.1.7 Do’s on the Response to Emergency Situations ......................................... 1-3

1.1.1.8 Do’s on the Disposal of Waste Oil, Waste Liquid, Scraps, etc. ................... 1-3

1.1.1.9 Other Do’s ................................................................................................... 1-3

1.1.2 Prohibitions (Don’ts) ........................................................................................... 1-3

1.2 Warning Notices in This Manual ................................................................. 1-3

1.3 Residual Risks ............................................................................................. 1-4

1.4 Safety Devices .............................................................................................. 1-6

Chapter 2 Product Specifications and Structure

2.1 Overview of This Product ............................................................................ 2-1

2.2 Model Designation of the Compressor ...................................................... 2-1

2.3 Product Specifications ................................................................................ 2-2

2.3.1 Standard Specifications ...................................................................................... 2-2

2.3.2 Service Limits ...................................................................................................... 2-4

2.3.3 Outer Dimensions ............................................................................................... 2-5

2.4 Structure of Semi-hermetic Motor .............................................................. 2-6

2.4.1 Sectional View of the Motor ................................................................................ 2-6

2.4.2 Parts Configuration Table ................................................................................... 2-7