Mylaps X2 - Maintenance; Periodic maintenance schedules; Cleaning

X2 transponder version 2018 © MYLAPS rights reserved 18
7.Maintenance
Maintenance can be described as, but not limited to:
• Checking and testing components;
• Cleaning the unit and individual components - accumulated dirt can hamper unit operations;
• Charging the unit;
• Troubleshooting any malfunctions that may occur on the unit during operation.
Periodic maintenance schedules
Type of maintenance
Daily
100 hours
300 hours
As required
Clean
X
X
Charging
X
Replace parts and accessories
X
Cleaning
Take a clean soft cloth or brush and moisten it with clean water
• Do not use an abrasive cleaning liquid.
• Do not use high pressure water guns or other (dish)washing machines to clean or rinse the transponders.
• Do not clean transponders with automotive cleaning products or other detergents.
• Use the moist cloth or brush to clean the X2 Transponder, paying attention to remove any dirt on the connector
pins. Dry off any excess moisture.
• Take a fresh clean cloth and moisten it with clean water.
• Clean the X2 Transponder making sure not to get moisture on the electrical connector where the USB cable can be
connected.
• Dry off any excess moisture.
• If necessary, use clean cotton tips to clean any dirt off the connectors on the X2 RaceKey and the X2 Transponder.