MZ electronic HC020 - Page 23

HC020 Rev. 02-2021
English
23
According to the type of parameter, using the (DOWN) and (UP) keys it is possible to
reduce/increase the value of the same or disable/enable the function.
Once the modification has been performed, press the (ON) key to confirm.
Using the (DOWN) key go to the Exit option and press the (ON) key again to return to
the setting menu. The same procedure must be used to return to the main page.
Working mode menu
WORKING MODE
EXIT
MODE CAP
Use the (DOWN) or (UP) key to move around the parameters.
Mode
Selects the working mode:
• Windlass (WND)
• Capstan (CAP)
Select with
Change with
Confirm with
Exit
To return to the previous menu
Confirm with
Measurement menu
UNITS MET
EXIT
MEASURE
RESET M.
Use the (DOWN) or (UP) key to move around the parameters.