N-Com BX4 PLUS - Basic Functions; System Menu

16
5. BASIC FUNCTIONS
All N-Com system functions are available through the operation of three pushbuttons: “+
”, “on” and “- ”. Every time the system is given a command, a special acoustic signal can
be heard, which varies depending on the function being requested, or on the vocal
command given. This way, all the functions can be used while wearing the helmet.
The type of command given to the system depends on how long the pushbutton is pressed.
System ON
Press “on” and keep it pressed for about 2 seconds, until the
LEDs turn on and you hear a beep in the headset.
System OFF
Press “on” and keep it pressed for about 5 seconds, until the
LEDs turn off and you hear a beep in the headset.
Increase Volume
Briefly press “+” to increase the volume. A double tone signals
the highest volume level.
Decrease Volume
Briefly press “-” to decrease the volume. A double tone signals
the lowest volume level.
5.1. System menu
BX4 PLUS features a menu with 3 functions: BASE, RADIO, BIKE TO BIKE (activated
upon request).
To scroll the card functions menu, press “on” for 2 seconds (with system turned on).
The switch from one function to the next is confirmed by a vocal message that indicates
the system status.
When BX4 PLUS is turned on, the menu is always in the “BASE” mode. Depending on
the menu position, you can manage the various audio devices and the available functions:
Menu Functions
Base
 Management of an external source connected via cable
 Use of Mobile phone/GPS with Bluetooth connection
 Use of the intercom “Rider–Pillion Passenger” or “Universal Intercom”
 Listening to and management of Bluetooth A2DP player
Radio
 Listening to and management of FM Radio
 Use of Mobile phone/GPS with Bluetooth connection
 Use of the intercom “Rider–Pillion Passenger” or “Universal Intercom”
Bike to
Bike
 Use of the intercom “Bike to Bike”
 Use of the intercom “Rider–Pillion Passenger” or “Universal Intercom”
Functions concerning Bluetooth mobile phone management are available in all menu
positions.
Note: The “Bike-to-Bike” menu must be specifically activated from the system (see
chapter 13) or by using the N-Com Wizard programme.