N-Com BX4 PLUS - Universal Intercom; Pairing up the UNIVERSAL INTERCOM; UNIVERSAL INTERCOM Function; UNIVERSAL INTERCOM Bike-to-Bike

24
14. “UNIVERSAL INTERCOM”
The N-Com BX4 PLUS system can be connected via Bluetooth to intercom systems of other
brands, thanks to the UNIVERSAL INTERCOM function.
14.1. Pairing up the UNIVERSAL INTERCOM
To pair up an N-Com system and an intercom of another brand (from now on called
Intercom B), the following procedure needs to be carried out:
 Put the N-Com system in the “Pair up Mode” by pressing the “on” key for more
than 4 seconds, until the LEDs start to flash quickly;
 Put Intercom B in the pair up mode of a mobile phone (please refer to the manual
of your specific Intercom B for additional information).
 Briefly press the “on” key on the N-Com system; after a few seconds, the two
systems will “recognize” each other and an acoustic message will indicate that the
pair up procedure was successful.
 To turn on the audio between the two helmets, press the “on” key on the N-Com
system.
14.2. UNIVERSAL INTERCOM function
After properly carrying out the pair up procedure, turn on both systems.
To turn on and off the audio between two helmets, proceed as follows:
1. FROM THE N-COM SYSTEM: press “on” on the N-Com system. Intercom B
receives an incoming call tone to which you need to answer with the call
answering button (please refer to the manual for Intercom B). To turn off the
intercom, briefly press the “on” key again.
2. FROM INTERCOM B: press the “Vocal Call” command. The N-Com system will
receive an incoming call tone. To turn off the intercom, press the “Vocal Call”
command again
N.B.:
 The N-Com systems keeps an active connection to a mobile phone or to a GPS even
during Bluetooth communication with other intercom systems.
 It may be that the intercom system hooked up to the N-Com does not allow for
simultaneous connection to a mobile phone.
14.3. UNIVERSAL INTERCOM Bike-to-Bike
The Universal Intercom function allows remote communication between two motorcycles. In
this case, connect the other motorcycle as if it was the passenger’s helmet.
N.B.: The range of the Bike-to-Bike communication depends on the range of the two
connected systems.