N-Tron 7026 Series - Show or Set CIP Configuration

For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2011-11-15) Page 140 of 169
CLI Commands, Continued…
Show or Set CIP Configuration
Command Name
Cip
Description
Show or set CIP configuration. If no parameters are specified, this command will show
the CIP configuration (same as -show parameter).
Syntax
-Cip [-e[nable] | -d[isable] | -show]
Parameters
-Cip –show
Show CIP configuration.
-Cip [-e[nable] | -d[isable]]
Set the CIP status to e(nabled) or d(isabled).
Examples
N-TRON/Admin> cip –show
CIP Configuration:
------------------
Status: Enabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 7026TX
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 1
Serial Number: 0xAFFBF8E0
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
N-TRON/Admin> cip -disable
Changing CIP configuration...
CIP Configuration:
------------------
Status: Disabled
EthIp Interval: 10 ms
Cache Interval: 2000 ms
Identity Information:
---------------------
Product Name: N-TRON 7026TX
Vendor: 1006 (N-TRON)
Device Type: 0x0C (Communications Adapter)
Major Revision: 1
Minor Revision: 1
Serial Number: 0xAFFBF8E0
Connection Information:
-----------------------
Multicast Connections: 0
Unicast Connections: 0
N-TRON/Admin>
NOTES