N-Tron 7026 Series - Page 167

For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2011-11-15) Page 167 of 169
</IPConfiguration>
<!-- ______________________________________________________________________________________ -->
<!-- User management -->
<!-- A list of logon accounts (5 maximum) to add to the switch. -->
<Users mode="keep or delete"> <!-- mode must be "keep" or "delete" -->
<!-- mode=delete - delete existing accounts before adding accounts (default) -->
<!-- mode=keep - do not delete existing accounts before adding accounts -->
<!-- All User elements (name, password, access) are required. -->
<User>
<Name>Joe</Name> <!-- 3-15 character limit -->
<Password>xxx</Password> <!-- 3-15 character limit -->
<Access>admin OR user</Access> <!-- Access must be admin or user -->
</User>
</Users>
<!-- ______________________________________________________________________________________ -->
<!-- Port configuration -->
<!-- You may uses this block to define port VLAN identifiers (PVIDs) -->
<Ports>
<ValidatePorts>yes OR no</ValidatePorts> <!-- optional --> <!-- Must be yes(default)
or no. If no, invalid ports are ignored. -->
<!-- Use PortNumber or PortName -->
<Port>
<PortNumber>4</PortNumber> <!-- PortNumber ranges from 1 to the maximum port
number for the switch -->
<PVID>1</PVID> <!-- PVID ranges from 1 to 4094 -->
</Port>
<Port>
<PortName>TX6</PortName> <!-- Name of port on switch -->
<PVID>26</PVID> <!-- PVID ranges from 1 to 4094 -->
</Port>
</Ports>
<!-- ______________________________________________________________________________________ -->
<!-- DHCP server -->
<DHCPServer mode="keep or delete"> <!-- mode must be "keep" or "delete" -->
<!-- mode=delete - delete existing profiles before adding profiles (default) -->
<!-- mode=keep - do not delete existing profiles before adding profiles -->
<Enabled>yes OR no</Enabled> <!-- Enabled must be yes or no -->
<!-- If the server is enabled (enabled=yes), you can add DHCP server profiles.
(If not enabled, can not add profiles.) -->
<Profile>
<!-- Required: Name, LowIP, HighIP, LeaseDays. LeaseHours is optional, and
defaults to 0. -->
<Name>prof1</Name> <!-- required --> <!-- 19 character limit -->
<LowIP>192.168.2.1</LowIP> <!-- required -->
<HighIP>192.168.2.254</HighIP> <!-- required -->
<LeaseDays>28</LeaseDays> <!-- required -->
<LeaseHours>0</LeaseHours> <!-- optional -->
<!--The Advanced block is optional, and all elements within the block are
optional.-->
<Advanced> <!-- optional -->
<!-- All elements below are optional -->
<BroadcastAddress>192.168.2.255</BroadcastAddress>
<DomainName>N-TRON.com</DomainName> <!-- 63 character limit -->
<DNSServer1>192.168.2.10</DNSServer1>