For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2011-11-15) Page 33 of 169
Following the Modify button, the administrator will see a list of configurable fields for the Fault
configuration. The fault relay contacts can be configured to open on fault or to close on fault, with the latter
being the default. Once these fields are filled in to meet the needs of the administrator‘s network, the
changes may be updated by clicking the Update button at the bottom of the page.
The example below shows the Modify Fault Configuration page on a switch with an AC power supply
installed.
If a low voltage DC power supply is installed, these additional choices appear:
To Next Page
Loading...
