N-Tron 710FX2 - Show or Set N-Ring Configuration; Show or Set N-View Configuration

(Revised 2012-05-01 Page 145 of 170
CLI Commands, Continued…
Show or Set N-Ring Configuration
Command Name
Nring
Description Show or set N-Ring configuration. If no parameters are specified, this command will
show the N-Ring configuration (same as -show parameter).
Syntax
nring
[-show] [-mode d | a | m] [-ports set_id]
Parameters
-show
Show configuration.
-mode
Set the N-Ring mode.
d = disabled, a = auto member, m = manager
-ports set_id
Set the ring ports for N-Ring manager mode.
Specify port set identifier or use ‘?’ to list available port sets.
Examples
N
-
TRON/Admin>
nring
–
show
N-Ring Mode : Auto Member
Aging Time : 20
N-TRON/Admin> nring –ports ?
ID Port Set
-- --------
1 TX1 / TX2
2 FX1 / FX2
N-TRON/Admin> nring –mode m –ports 2
Do you Want to Save Changes and Restart the System Now [y/n]?
…
NOTES
Show or Set N-View Configuration
Command Name
Nview
Description Show or set N-View configuration. If no parameters are specified, this command will
show the N-View configuration (same as -show parameter).
Syntax
nview
[-show] [-status state]
Parameters
-show
Show configuration.
-status state
Set the N-View status to e(nabled) or d(isabled).
Examples
N-TRON/Admin> nview –show
N-View Status : Enabled
N-View Interval : 5
N-TRON/Admin> nview –status disabled
N-View Status : Disabled
N-View Interval : 5
Changes have been made that have not been saved.
…
NOTES