Need help?Do you have a question about the NAD 713 and is the answer not in the manual?
General| Brand | NAD |
|---|---|
| Model | 713 |
| Category | Stereo Receiver |
| Language | English |
Warnings about opening the unit, dangerous voltages, and qualified personnel access.
Do not expose to rain/moisture, ensure proper ventilation, avoid heat sources.
Do not attempt self-servicing, use authorized parts, unplug before cleaning or long periods of non-use.
Warning against using polarized plugs with extension cords unless blades are fully inserted.
Outdoor antennas must be clear of power lines; grounding is required.
Inputs for PHONO, CD, TAPE 1/2, VIDEO 1/2, and outputs like MONO OUT.
Connects front speakers for main listening area, switched via SPEAKER A button.
Connects speakers for secondary listening area, switched via SPEAKER B button.
Connects the center speaker for Dolby Pro-Logic or Hall modes.
Sets delay times for surround speakers in Dolby Pro-Logic/Hall modes.
Guides through manual tuning, automatic search, and storing stations into memory.
Explains how to retrieve stored radio stations using PRESET and BANK buttons.
Use test signal to adjust speaker levels for equal loudness at the listening position.
Adjusts the relative loudness of center and surround speakers using remote controls.
Sets surround delay based on distances between speakers and listener for optimal timing.
Discusses the critical role of speaker placement in achieving optimal Pro-Logic surround performance.
Mounting surround speakers high up on walls for diffuse room-filling audio effects.
Enhances dialogue clarity, stabilizes stereo image, and widens listening area.
Warns about using magnetically shielded speakers near TVs to prevent picture distortion.
Reproduces low-frequency effects difficult for standard speakers; uses MONO output.
How to check and correct speaker phasing for optimal sound and bass response.
Describes a sophisticated home theater system centered around the AV 713.
Addresses problems like no sound, single-channel sound, or no surround/center channels.
Troubleshooting for inoperative Pro-Logic/Hall modes, or issues with surround/center channels.
Solutions for remote control malfunction and tuner noise (hiss, distortion, interference).
Output power, dynamic power, continuous power, distortion, damping factor, and impedance details.
Lists specifications for FM and AM tuner sensitivity, selectivity, and signal-to-noise ratios.
To Next Page
