Need help?Do you have a question about the NAD 7140 and is the answer not in the manual?
General| Damping Factor | 50 |
|---|---|
| Input Sensitivity (MM) | 2.5 mV |
| Input Sensitivity (Line) | 150 mV |
| Signal to Noise Ratio (MM) | 80 dB |
| Power Output | 40 watts per channel (8 ohms) |
| Frequency Response | 20 Hz - 20 kHz |
| Speaker Load Impedance | 4-16Ω |
Details continuous average power output and distortion for stereo mode.
Lists continuous average power output for bridged monophonic mode.
Covers phono and line level input sensitivities and output characteristics.
Details sensitivity, selectivity, and stereo separation for FM reception.
Lists usable sensitivity and selectivity for AM reception.
Provides an internal view of the unit's components.
Shows how to connect test equipment for alignments.
Checks and adjusts tuning voltage for the oscillator.
Aligns RF stages for optimal signal tracking across frequencies.
Adjusts the IF section for maximum and symmetrical curve.
Covers coarse and final adjustments for the FM detector circuit.
Sets the threshold for the auto-search tuning function.
Adjusts VCO and checks suppression for stereo decoding.
Adjusts R249 and R250 for optimal stereo separation.
Calibrates the synthesizer frequency using a known source.
Adjusts oscillator voltage at specific frequencies.
Aligns antenna and IF stages for maximum signal readings.
Adjusts signal strength indication and auto-stop level.
Sets quiescent current for the amplifier's output stage.
Centers speaker terminal DC voltage to minimize distortion.
Diagram showing component placement on the amplifier PCB.
Diagram showing component placement on the tuner PCB.
Circuit diagram for the amplifier section of the receiver.
Illustrates electrical connections between different parts of the unit.
Circuit diagram for the tuner section of the receiver.
Lists parts with reference numbers from an exploded view.
Comprehensive list of electrical components used in the unit.
To Next Page
