Need help?Do you have a question about the NAD 7125 and is the answer not in the manual?
General| Power Output | 25 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Total Harmonic Distortion | 0.03% |
| Damping Factor | 50 |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Speaker Load Impedance | 4Ω to 16Ω |
| Signal to Noise Ratio | 95dB (line) |
| Dimensions | 420 x 96 x 240mm |
| Channel Separation | 50dB |
Description of threaded metal shafts with thumbscrews for antenna wire connection.
Guidance on connecting external antennas for optimal AM and FM broadcast reception.
Connecting turntables, auxiliary sources, and tape decks to the receiver's inputs.
Instructions for connecting loudspeakers, including wire gauge and ensuring proper phasing.
How to adjust the speaker impedance selector for optimal power output.
Connecting the AC power cord and utilizing the unswitched AC convenience outlet.
Description of controls for power, headphones, bass, treble, balance, and volume.
Explanation of loudness compensation and bass equalization features.
Using the tape monitor and storing favorite FM/AM stations in memory presets.
Operating the up/down tuning controls and entering station frequencies into presets.
Mono/stereo switching, fast scan tuning, tuning display, and FM stereo beacon.
Description of the power indicator and notes on overload protection.
To Next Page
