Your mobile device will
now connect to your
NAD amplifier.
Connecting to
Chromecast built-in
amplifier
Your mobile device will switch to a
temporary Wi-Fi hotspot on your
Chromecast built-in amplifier.
Successfully connected
to your Chromecast
built-in amplifier
Chromecast built-in
amplifier found
CONTINUE
Tap Continue to
connect to your NAD
amplifier.
10
Once your
mobile device
has successfully
connected to
the amplifier in
the Google
Home app, you
will be directed
to “Play Test
Sound”
Select the NAD Chromecast
built-in amplifier listed and tap
Set Up Continue
NADAmpC338…
Needs Setup
DISMISS
SETUP
9
PLEASE NOTE STEP #9 applies ONLY
to Android.
IMPORTANT! Follow these installation steps to add Chromecast casting capability to your C 338 amplifier.
C 338
Chromecast Built-In
8
Device has
been found
Open the Google
Home app.
Tap Devices in the
top right corner of
the screen
7
Settings
Airplane Mode
Wi-Fi
Bluetooth On
Notifications
Control Center
Do Not Disturb
General
Once the unit is
in hotspot mode,
go to the
Settings menu
Wi-Fi
CHOOSE A NETWORK
Settings
Wi-Fi
DefaultWiFi
NADAmpC338…
B45OSix
Select Wi-Fi
You may now select the
NAD network
6
Your NAD C 338 is now in
hotspot mode and ready for
Wi-Fi setup
5
Light
Indicator
Press the front panel standby
button and wait for the power
indicator light to be a steady
pulsing blue
4
Set the POWER switch to ON at
the rear panel of the amplifier
2
Plug in the NAD C 338 and
connect each supplied antenna
to their corresponding
terminals on the rear panel
3
Connect a pair of speakers to the
amplifier’s corresponding right/left speaker
terminals. Double-check the speakers
before powering on the amplifier
1
Install the Google
Home app on your
mobile device
(If not already installed)
PG 1
PLEASE NOTE STEP #7 applies ONLY to iOS.
To Next Page
Need help?
General
Weight and Dimensions
