NAD C 355BEE - User Manual

Other manuals for NAD C 355BEE

Questions and Answers

S
sullivanjacobAug 1, 2025
Why does the Power/Stand-by/Protection LED turn red on my NAD Amplifier?
- M
  Mark WiseAug 1, 2025
  If your NAD Amplifier shows a red light on the Power/Stand-by/Protection LED during operation, it indicates that the amplifier has overheated or the impedance of your loudspeakers is too low. First, turn the amplifier OFF and check that the ventilation slots on the top and bottom are not blocked. Allow the amplifier to cool down before turning it back ON. Also, ensure that the overall loudspeaker impedance is not below 4 ohms.
A
Ashley HernandezAug 6, 2025
How to fix no sound on NAD Amplifier?
- N
  nguyenrogerAug 7, 2025
  If your NAD Amplifier has no sound, check the following: * Ensure the AC lead is plugged in and the power is switched ON. * De-select Tape Monitor mode. * Switch off Mute. * Fit links to the rear Pre-out/Main-in. * Disconnect headphones.
M
mackamandaAug 12, 2025
Why is there no sound in one channel of my NAD Amplifier?
- A
  amandayuAug 12, 2025
  If you're experiencing no sound in one channel of your NAD Amplifier, try these steps: * Center the Balance control. * Check the speaker connections and the speakers themselves for damage. * Inspect the input leads and their connections for any disconnections or damage.
B
Belinda EdwardsAug 19, 2025
What to do if the NAD Amplifier remote control is not working?
- R
  Rodney RussellAug 19, 2025
  If the remote control handset for your NAD Amplifier is not working, check the following: * Ensure the battery is not flat and is correctly inserted; replace if necessary. * Make sure there are no obstructions blocking the IR transmitter or receiver windows; remove any obstructions. * Ensure the IR receiver is not in direct sunlight or very bright ambient light; move the unit away from direct sunlight or reduce the ambient light.
D
danielle32Aug 25, 2025
Why does my NAD Amplifier have weak bass and a diffused stereo image?
- M
  michellemarshAug 26, 2025
  If your NAD Amplifier produces weak bass or a diffused stereo image, it might be due to speakers wired out of phase. Check the connections to all speakers in the system to ensure they are correctly wired.