Why is there no sound coming from my NAD C 326BEE Amplifier?
If there is no sound coming from your NAD Amplifier, there might be several reasons. First, check if the AC lead is properly plugged in and the power is switched ON. Ensure that the Tape Monitor mode is de-selected and that the Mute function is switched off. Lastly, verify that the rear Pre-out/Main-in amp links are fitted correctly.
How to fix NAD C 326BEE Amplifier when there is no sound in one channel?
If you're experiencing sound in only one channel of your NAD Amplifier, begin by centering the Balance control. Next, inspect the speaker connections and the speakers themselves for any damage or loose connections. Finally, check the input leads and connections to ensure they are properly connected and not damaged.
What to do if there is no sound from the Subwoofer connected to NAD C 326BEE?
If there is no sound coming from the subwoofer connected to your NAD Amplifier, ensure the subwoofer is powered on and check its AC outlet. Also, check all connections to make sure they are properly connected.
How to troubleshoot weak bass or diffused stereo image on NAD C 326BEE Amplifier?
To troubleshoot weak bass or a diffused stereo image on your NAD Amplifier, check the connections to all speakers in the system to ensure they are wired in phase.
What to do if remote control of NAD C 326BEE is not working?
If the remote control handset for your NAD Amplifier is not working, start by checking or replacing the battery, ensuring it's correctly inserted. Then, make sure there are no obstructions blocking the IR transmitter or receiver windows. Also, avoid placing the unit in direct sunlight or very bright ambient light, as this can interfere with the IR receiver.
Why does the standby LED on my NAD C 326BEE turn red during operation?
If the standby LED on your NAD Amplifier turns red during operation, it could be due to overheating or low loudspeaker impedance. Turn the Amplifier OFF and ensure that the ventilation slots on the top and bottom are not blocked. After it has cooled down, turn it back ON. Also, make sure the overall loudspeaker impedance is not below 4 ohms.
Detailed steps for safely replacing the fuses in the C 326BEE amplifier.
Detailed technical data for the C 326BEE's pre-amplifier circuitry.
Detailed technical data for the C 326BEE's power amplifier circuitry.
General| Weight | 6.9 kg |
|---|---|
| Total Harmonic Distortion | 0.03% |
| Input Sensitivity | 200mV (line level) |
| Dimensions | 435 x 100 x 286 mm |
| Input Impedance | 47k Ohms |
| Inputs | 7 x Line Level |
| Outputs | 1 x Headphone |
| Power Output | 50W into 8 Ohms (20Hz - 20kHz at 0.03% THD) |
| Frequency Response | 20Hz - 20kHz (+0dB to -0.3dB) |
To Next Page
