NAD C 338 Quick Start Guide

IMPORTANT! Follow these installation steps to add Chromecast casting capability to your C 338 amplifier.
C 338
Chromecast Built-In
7
Device has
been found
Open the Google Home app.
Tap Devices in the top right
corner of the screen
6
Your NAD C 338 is now in
hotspot mode and ready for
Wi-Fi setup
5
Light
Indicator
Press the front panel standby
button and wait for the power
indicator light to be a steady
pulsing blue
4
Set the POWER switch to ON at
the rear panel of the amplifier
2
Plug in the NAD C 338 and
connect each supplied antenna
to their corresponding
terminals on the rear panel
3
Connect a pair of speakers to the
amplifier’s corresponding right/left speaker
terminals. Double-check the speakers
before powering on the amplifier
1
Install the Google
Home app on your
mobile device
(If not already installed)
CONTINUE
9
Tap Continue once your
mobile device has
successfully connected
to the amplifier in the
Google Home app
8
Select the NAD Chromecast
built-in amplifier listed and tap
Set Up Continue
Your mobile device will now
connect to your NAD amplifier
NADAmplifierDF432A
Needs Setup
Devices
IGNORE
SETUP
PG 1

NAD C 338 Specifications

General

Amplifier class	-
Audio output channels	- channels
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	- %
RMS power output per channel (4 Ohm)	50 W
Purpose	Home
Product color	Graphite
Volume control	Rotary
Turntable connectivity	Yes
Connectivity technology	Wired & Wireless
Package weight	5850 g
Certification	CE
Headphone connectivity	3.5 mm

Weight and Dimensions

Depth	285 mm
Width	435 mm
Height	70 mm
Weight	4850 g