CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
No power. • The power cord is disconnected. • Plug the power cord into the wall outlet
securely.
The power is on, but the C 516BEE does
not work.
• No disc is inserted. • Insert a disc.
The C 516BEE does not start playback. • The disc is loaded upside down. • Reload the disc with the label side UP.
• The disc is too dirty. • Clean the disc.
No sound. • The equipment connected with the audio
cable is not set to receive CD signal output.
• Select the correct input mode of the audio
receiver so you can listen to the sound from
the C 516BEE.
• The power of the equipment connected with
the audio cable is turned o.
• Turn on the equipment connected with the
audio cable.
Sound skips. • The C 516BEE is subject to vibration or physical
shock from external sources.
• Change the installation location.
The remote control does not work properly. • The remote control is not pointed at the
remote sensor on the CD player.
• Point the remote control at the remote
sensor of the CD player.
• The remote control is too far from the CD
player.
• Operate the remote control closer to the
CD player.
• The remote control batteries are dead. • Replace the remote control batteries.
REFERENCE
TROUBLESHOOTING
NOTES ON DISCS
HANDLING DISCS
Do not touch the playback side of the disc. Hold the disc by the edges so that
ngerprints do not get on the surface. Never stick paper or tape on the disc.
STORING DISCS
After playing, store the disc in its case. Do not expose the disc to direct
sunlight or sources of heat and never leave it in a parked car exposed to
direct sunlight.
CLEANING DISCS
Fingerprints and dust on the disc can cause poor picture quality and sound
distortion. Before playing, clean the disc with a clean cloth. Wipe the disc
from the center out.
Do not use strong solvents such as alcohol, benzine, thinner, commercially
available cleaners, or anti-static spray intended for older vinyl records.
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
