To Next Page
J
joseph14Aug 20, 2025
What to do if the tray won't open on my NAD CD Player?
- YYolanda WebbAug 20, 2025
If the tray won't open, check the open/close signal at U401 PIN 66, 65.
What to do if the tray won't open on my NAD CD Player?
If the tray won't open, check the open/close signal at U401 PIN 66, 65.
What to do if the tray won't close on my NAD CD Player?
If the tray refuses to close, examine the open/close signal at U401 PIN 65 PIN 66.
What to do if my NAD CD Player displays 'TRAY OPEN'?
If your NAD CD Player displays 'TRAY OPEN', check the open/close signal at U401 PIN 65 PIN 66.
What to do if my NAD CD Player displays 'TRAY CLOSE'?
If the display shows 'TRAY CLOSE', check the open/close signal at U401 PIN 65 PIN 66.
Why does my NAD CD Player not play discs?
If your NAD CD Player isn't playing discs, verify that the tracking servo circuit is correct.
Why does initial reading not occur on my NAD CD Player?
If initial reading does not occur, check the laser light, ensure the lens moves up and down, and verify the focus signal output.
Why is there no sound coming from my NAD CD Player?
If you're not getting any sound from your NAD CD Player, first, double-check that the audio cables are correctly connected between the CD player and your amplifier or receiver. Also, ensure that the input selector on your amplifier or receiver is set to the correct CD input. The issue may be due to incorrect audio cable connections or incorrect amplifier/receiver operation.
What to do if the NAD C 542 CD Player remote control does not work?
If the remote control for your NAD CD Player isn't working, the batteries in the remote might be dead, so try replacing them. Also, make sure there's nothing blocking the remote sensor on the player. The problem may arise because batteries in the remote control handset have expired or there's an object obscuring the remote sensor on the player.
What to do if my NAD CD Player disc play does not start?
If your NAD CD Player isn't starting disc playback, make sure the disc is loaded with the label side up. Also, check if the disc is dirty, and if so, clean it. The disc may be loaded upside down or the disc may be too dirty.
How to fix sound skipping on NAD C 542 CD Player?
If the sound skips on your NAD CD Player, the player might be subject to vibration or physical shock from external sources. Try changing the installation location to avoid these disturbances.
General| Type | CD Player |
|---|---|
| Signal-to-Noise Ratio | >110dB |
| Frequency Response | 20Hz - 20kHz |
| Channel Separation | >95dB |
| Digital Output | Coaxial |
| Digital-to-Analog Converter (DAC) | 24-bit/192kHz Delta-Sigma |
| Output Impedance | 100 Ohms |
