PREAMPLIFIER SECTION
LINE LEVEL INPUT, PRE OUT
THD
1
20 Hz – 20 kHz, CCIF IMD, SMPTE IMD, DIM 100 <0.005 % at 2 V out
Signal-to-Noise Ratio >106 dB (IHF; A-weighted, ref. 500 mV out, unity gain)
>114 dB (A-weighted, ref. 2 V out, Volume maximum)
>92 dB (ref. 100 mV out, unity gain)
Channel separation -1 kHz >80 dB
10 kHz >68 dB
Input impedance (R and C) 22 kohms+ 100 pF
Maximum input signal >6 Vrms (ref. 0.1 % THD)
Output impedance - Pre out 80 ohms
Tape out Source Z + 1 kohm
Input sensitivity 166 mV (ref. 500 mV out)
Frequency response ±0.3 dB (20 Hz - 20 kHz, Tone defeat ON)
±0.3 dB (20 Hz - 20 kHz, Tone defeat OFF)
Maximum voltage output -IHF load >10 V (ref. 0.03 % THD)
600 ohms load >8 V (ref. 0.03 % THD)
TONE CONTROLS Treble ±5 dB at 10 kHz
Bass ±8 dB at 100 Hz
POWER AMPLIFER SECTION
MAIN IN, SPEAKER OUT
Continuous output power into 8 ohms and 4 ohms (Stereo) >80 W (at rated THD, 20 Hz-20 kHz, both channels driven)
Rated THD
1
20 Hz – 20 kHz, CCIF IMD, SMPTE IMD, DIM 100 <0.007 %
Clipping power >90 W (at 1 kHz 0.1 % THD)
IHF dynamic headroom - 8 ohms +2.6 dB
4 ohms +4.4 dB
IHF dynamic power - 8 ohms 145 W
4 ohms 220 W
2 ohms 290 W
Peak output current >50 A (in 1 ohm, 1 ms)
Signal-to-noise ratio >101 dB (A-weighted, ref. 1 W)
>120 dB (A-weighted, ref. 80 W)
Damping factor >100 (at 8 ohms, 50 Hz and 1 kHz)
Frequency response ±0.3 dB (ref. 20 Hz - 20 kHz)
3 Hz – 70 kHz (ref. -3 dB)
Input impedance 20 kohms + 1 nF
Input sensitivity 950 mV (for 80 W in 8 ohms)
Voltage gain 29 dB
Headphone output impedance 220 ohms
Channel separation - 1 kHz >80 dB
10 kHz >70 dB
TRIGGER OUT
Output resistance 75 ohms
Output current 150 mA
Output voltage +12 V ± 10 %
REFERENCE
SPECIFICATIONS
15
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ
To Next Page
Loading...
