Need help?Do you have a question about the NAD C399 and is the answer not in the manual?
Details guidelines for proper ventilation and spacing around the unit.
Covers initial setup steps like unboxing, choosing a location, and factory reset procedures.
Describes the buttons, indicators, display, and ports on the front of the unit.
Details the various connectors and controls found on the rear of the NAD C 389.
Explains the MDC2 architecture and its role in future upgrades.
Describes the optional MDC2 BluOS-D module for streaming services and multi-room audio.
Details the functions and operation of the included SR 10 remote control handset.
Details how to operate the NAD C 389 amplifier, covering various functions and settings.
Lists detailed technical specifications measured according to industry standards.
General| Signal-to-Noise Ratio | >95dB (A-weighted, 500mV input, ref. 1W out in 8 ohms) |
|---|---|
| Outputs | Speaker A, Speaker B, Subwoofer, Pre-out, Headphone |
| Digital Inputs | 2 x Optical, 2 x Coaxial, 1 x HDMI eARC, 1 x USB |
| DAC | ESS Sabre ES9028Q2M |
| Power Output | 180W per channel (8 ohms) |
| Frequency Response | 20Hz-20kHz |
| Inputs | 2 x Optical, 2 x Coaxial, 1 x USB |
| Weight | 11.2 kg |
| Clipping Power | 200W (8 ohms) |
| IHF Dynamic Power | 260W (8 ohms) |
| Channel Separation | >70dB (1kHz) |
| Analog Inputs | 2 x RCA |
| Bluetooth | aptX HD |
| Input Impedance | 47k Ohms |
| USB DAC | Up to 24-bit/192kHz |
| THD+N | <0.005% (20Hz-20kHz, 8 ohms) |
To Next Page
