NAD C399 - Analog Bypass; Analog Gain; System Info

ENGLISH
20
ANALOG BYPASS
All analog signals remain in the analog domain without analog-to-digital
conversions.
On: DSP circuitry is bypassed but full tone control functions remain.
O: Analog bypass feature is turned off.
NOTE
Analog Bypass is applicable only for Phono, Line 1 and Line 2 sources.
ANALOG GAIN
• Use front panel [a/s] or SR 10’s [A/S] buttons to set preferred Analog
Gain level.
NOTE
Analog Gain is applicable only for Phono, Line 1 and Line 2 sources.
SYSTEM INFO
“System Info” displays information about current MCU, LCD and FPGA
firmware versions.
Use [a/s] to toggle through the corresponding information.
If the optional MDC2 BluOS D is installed, the BluOS firmware version, IP
Address, MAC Address (Ethernet) and MAC Address (Wi-Fi) information are
also shown.
UPGRADE AVAILABLE
With the optional MDC2 BluOS D installed and C 389 connected to internet,
“Upgrade Available” will be shown if a software upgrade is available.
If “Upgrade Available” is shown, use [f] to go to BluOS upgrade menu.
Press [ENTER] to initiate upgrade mode. Internet software upgrade will
proceed automatically.
OPERATION
USING C 389