IMPORTANT NOTICE REGARDING FIRST TIME SETUP OF NAD T 747
The T 747 includes a high performance video processor that can upscale
Standard Definition (SD) video to High Definition (HD) video. The HD video is
only available on the HDMI (up to 1080p resolution) or Component Video (up to
1080i resolution only) output.
If you are using an HD capable TV, you should connect either HDMI or
Component Video, not both. All SD sources will be upscaled to HD over these
HD connections. Be sure your TV is HD capable before selecting an HD
resolution. Note that the default SD is backward compatible with non-HD sets.
For the On Screen Display (required for Setup) to be shown at your connected
TV, set your T 747 to the Source number that corresponds to your TV’s signal
type:
Source 1 = defaulted to HDMI Monitor OUT
Source 2 = defaulted to Component Video Monitor OUT
Source 3 = defaulted to S-Video Monitor OUT
These default settings can be changed, but should be used to get started. It must
be noted from the above that with Source 1 defaulted to HDMI, the On Screen
Display will only be available via HDMI Monitor OUT when at Source 1. Select
Source 2 or other enabled Source numbers (except Source 1) for the On Screen
Display to be available at Component Video, S-Video or Video (Composite)
Monitor OUT.
®
T 747
AV Surround Sound Receiver
To Next Page
Need help?
General
