Quick Start Guide
The scanner support 3 connections: Bluetooth mode + wireless mode
+ wired mode.
It is suggested to use 2.4GHz wireless mode & wired mode on the
computer, use bluetooth mode on the smartphone, tablets.
1. Bluetooth Mode Quick Start Guide
--To use the scanner on Android / iOS device
Step1. Scan the following code “Bluetooth mode”to set the scanner
to bluetooth mode. The blue and green light will flash alternately.,
which means the scanner enters into bluetooth mode.
Step 2. Scan the code “ Match" to start paring the scanner, at this
time, the green light is off and the blue light is blinking.
Step 3. Enable bluetooth function on your device till find out
“ScannerHID”, and click it to pair. Wait a few seconds, the blue light
will be on steady and the buzzer beeps once, which means bluetooth
pairing is successful.
Step 4. Scan the code “Instant Upload Mode”to set the scanner
instantly upload barcode.
To Next Page
Loading...
