Need help?Do you have a question about the NAIM NAIT XS 3 and is the answer not in the manual?
General| Power Output | 70W per channel into 8 ohms |
|---|---|
| Outputs | Headphone Output |
| Dimensions | 70 x 432 x 314 mm (H x W x D) |
| Input Impedance | 47kΩ |
| Mains Supply | 230V, 50/60Hz |
| Headphone Output | 6.35mm jack |
| Frequency Response | 10Hz |
| Input Sensitivity | 130mV |
Guidance on using DIN or RCA interconnect sockets and keeping them clean for optimal performance.
Recommendations for loudspeaker cable length, quality, and Naim's directional cable usage.
Instructions for correctly wiring mains plugs to Naim supplied leads, matching wire colours to terminals.
Advice on replacing fuses with identical ones and investigating repeated fuse failures.
Safety warning regarding the disposal of cut-off non-rewirable plugs to prevent shock hazards.
Correct sequence for switching components on/off and handling potential loudspeaker 'thumps'.
Essential safety advice to protect equipment from lightning damage by disconnecting mains.
Overview of the NAIT 5si front panel controls including input selection and volume.
Diagram and explanation of rear panel input/output sockets and connector types.
Connect the NAIT 5si to mains power using the supplied cable or Naim Power-Line.
Details on front panel input buttons and rear panel RCA/DIN sockets for audio sources.
Information on stereo speaker connection sockets and using Naim connectors for safety.
To Next Page
