Need help?Do you have a question about the NAIM NAIT3 and is the answer not in the manual?
General| Signal to Noise Ratio | > 90dB |
|---|---|
| Power Output | 30W per channel into 8 ohms |
| Total Harmonic Distortion | <0.1% |
| Input Impedance | 47k ohms |
| Outputs | Speaker Outputs |
| Frequency Response | 10Hz - 20kHz ±0.5dB |
| Inputs | 4 x Line, 1 x Phono |
Proper installation of interconnect and loudspeaker cables, emphasizing directionality and correct connectors.
Sequence for switching on/off power supplies and amplifiers, and capacitor discharge time.
Explains the time it takes for equipment to reach optimal performance and benefits of leaving it on.
Details on fuse types, ring mains, and spur connections for optimal sound quality.
Guidance on positioning equipment to avoid interference and hum.
Advice on seeking dealer support, troubleshooting, and authorized repairs.
Discusses potential mechanical noise from transformers and radio frequency interference issues.
Advises on protecting equipment from lightning damage by switching off and unplugging.
Critical safety warnings on using approved connectors, unauthorized modifications, and opening equipment.
Details on the different input types and their assignments for various sources like tape recorders.
Explains the function of the monitor button for listening to tape output during recording.
Emphasizes using Naim Audio's specified speaker cable and connectors for safety and performance.
To Next Page
