Need help?Do you have a question about the NAIM NAIT 50 and is the answer not in the manual?
General| Power Output | 25W per channel into 8 ohms |
|---|---|
| Input Sensitivity | 150mV |
| Weight | 7 kg |
| Signal to Noise Ratio | 80dB |
| Analogue Inputs | 3 x RCA |
| Input Impedance | 47kΩ |
| Mains Supply | 115V or 230V |
| Headphone Output | 6.35mm jack |
| Inputs | 3 x RCA, 1 x DIN |
| Distortion | <0.1% (20Hz - 20kHz at 50W) |
Lists the components included with the NAIT 50 amplifier.
Details the LED brightness levels for NAIT 50 active and standby modes.
Guidance on placing the NAIT 50 for optimal performance and avoiding interference.
Explains the DIN and RCA input types for connecting sources to the NAIT 50.
Recommendations for loudspeaker cables and ensuring correct speaker connections.
Instructions for powering the NAIT 50 on and off, and power sequencing.
Details auto standby and 'instant on' modes for power management.
Importance of system ground connection to mains earth for optimal sound.
Safety warning regarding the disposal of cut-off mains plugs.
Discusses mains power circuits, potential hum, and interference.
Safety advice to disconnect power during lightning risk.
Advice on how components 'run-in' and improve over time.
Instructions for cleaning the product and maintaining connections.
To Next Page
