Need help?Do you have a question about the NAIM NAC 332 and is the answer not in the manual?
General| Type | Preamplifier |
|---|---|
| Channels | 2 |
| Input Impedance | 47 kΩ |
| Output Impedance | 50 Ω |
| Signal to Noise Ratio | > 100 dB |
| Dimensions | 87 x 432 x 314 mm (H x W x D) |
| Outputs | 1 x RCA |
| THD + N | < 0.005% |
| Analogue Inputs | 2 x RCA, 2 x DIN |
| Frequency Response | 10 Hz - 20 kHz (±0.1 dB) |
Details connecting the NAC 332 to Naim power amplifiers using XLR and automation cables.
Explains connecting various audio sources to the NAC 332's input terminals.
Guides on connecting mains power and initiating the NAC 332 and amplifier power-up sequence.
Describes how to change input assignments for front panel and remote control buttons.
Details adjusting the relative level for each input to equalize volume between sources.
Allows setting an overall maximum volume level to prevent accidental high volumes.
Discusses signal ground connection to mains earth and the ground lift switch operation.
To Next Page
