Need help?Do you have a question about the NAIM NAC 112 - ISSUE 2 and is the answer not in the manual?
General| Type | Preamplifier |
|---|---|
| Weight | 5.5 kg |
| Input impedance | 47 kΩ |
| Inputs | 4 x Line |
| Outputs | 2 x Tape |
| Analogue inputs | 4 |
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | 90 dB |
| Distortion | <0.05% |
Guidance on the proper installation of Naim Audio equipment.
Best practices for connecting Naim interconnect and loudspeaker cables.
Important safety advice for operating Naim audio equipment.
Steps to resolve problems and contact support for Naim equipment.
Correct wiring procedures for mains leads and plug assemblies.
Comprehensive guide to setting up and operating the NAC 552.
Diagram and instructions for connecting the NAC 552 to its power supply.
Comprehensive guide to setting up and operating the NAC 252.
Diagram and instructions for connecting the NAC 252 to its Supercap power supply.
Comprehensive guide to setting up and operating the NAC 282.
Connecting the NAC 282 to Hi-Cap and Supercap power supplies.
Comprehensive guide to setting up and operating the NAC 202.
Connecting the NAC 202 to its Hi-Cap power supply.
Comprehensive guide to setting up and operating the NAC 112.
Connecting the NAC 112 to a Flatcap 2 power supply unit.
Programming preamplifier, CD, and tuner functions with the Flash handset.
Using system component, global, and soft keys on the Narcom 3 handset.
To Next Page
