DIM:
100%
*
FX: OFF
CH: 3
2. Installation Instruction of Reflector
When installing the reflector, make sure its
mount points line up with the slots on the
light fixture. When the mount points and
slot are lined up push the reflector in place
rotate reflector in the locking direction as
describe on light until you hear it click into place.
When removing the reflector, push
and hold on lock catch until rotating
the reflector and you are able to
remove it from fixture.
The reflector lock on/off mark.
Operating Instructions
1. Wiring (sketch maps as below)
Be sure that the power switch is
in the "off " position.
Connect the power adapter with
the fixture. If the power indicator is
on that means the power supply is
nominal.
The LCD screen will display
all the relevant information for
the fixture.
Lock catch
4
To Next Page
