NanoCam Plus NCP-DVRT1 - Settings Menu Details; G-Sensor

10
2.7.2 Loop Recording
Loop recording allows you to set the duration that the camera will record before creating a new clip. To set the clip length
please follow the instructions below.
1. Press the
(OK) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Settings Menu.
3. Use the
and Buttons to navigate the Settings Menu and highlight the Loop Recording setting and press (OK)
to select.
4. Use the
and Buttons to highlight your required clip Length, then press the (OK) button to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. To avoid filling the card quickly it is advised to use the 2 or 3 minute options.
2.7.3 Motion Detection
Motion Detection is used to pause recording when no motion is detected in front of the camera, and to start recording
when motion is detected again. To activate the Motion Detection setting follow the instructions below.
1. Press the
(OK) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Settings Menu.
3. Use the
and Buttons to navigate the Settings Menu and highlight the Motion Detection setting and press (OK)
to select.
4. Use the
(OK) Button to turn OFF and ON Motion Detection indicated by the check box.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.4 G Sensor
The G Sensor defines the required force needed to trigger emergency recording. Once Emergency recording is triggered
the current recording will be saved and protected from being saved over by the normal loop recording. To set the required
sensitivity please follow the instructions below.
1. Press the
(OK) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Settings Menu.
3. Use the
and Buttons to navigate the Settings Menu and highlight the G Sensor setting and press (OK) to
select.
4. Use the
and Buttons to turn highlight your required sensitivity, then press (OK) to confirm your selection.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.