EasyManua.ls Logo

NAPCO GEM-K4 - System Trouble Error Codes; E-08 Telephone Line Cut; E-10-NN Keypad Response Failure

NAPCO GEM-K4
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
SYSTEM TROUBLE ERROR CODES
Trouble
Indication
System Trouble
Condition
Action
E-04-NN
Wireless Transmitter
Supervisory Failure
A problem has been detected with a wireless transmitter. Call installing company for service.
E-05-NN
Wireless Transmitter
Low Battery
The battery in a wireless transmitter is low and should be replaced. This transmitter is on the zone
corresponding to the number NN. The replacement battery for the GEM-TRANS2 door/window transmitter,
GEM-PIR motion detector and GEM-GB glass break detector is the Duracell DL123A 3 volt lithium. (2
required for the GEM-PIR and GEM-GB.) The replacement battery for the GEM-SMK is the Duracell
MN1604 9 Volt Alkaline(2 required ). The GEM-DT Dual Technology Sensor requires 4 C cell alkaline
batteries.
Warning: Replace batteries only with the same type as specified above. Use of another battery may present
a risk of fire or explosion. Do not recharge or disassemble battery, or dispose of in fire.
E-06-NN
Receiver Response
Failure
Call installing company for service.
E-07-00
Download Failure Call installing company for service.
E-08
Telephone Line Cut The telephone line has failed. If telephone service has been temporarily interrupted, the trouble will clear
automatically when it is restored. Otherwise, call installing company for service.
E-09-00
System Cold Start
E-10-NN
Keypad Response
Failure
Call installing company for service.

Related product manuals