Need help?Do you have a question about the NAPCO GEM-K4 and is the answer not in the manual?
Instructions for testing the sounding device and backup battery.
Instructions for testing the central station communicator.
Steps to arm the system in Away mode.
Procedure for arming when zones are faulted.
How to manually bypass zones from the system.
Steps to arm the system in Stay mode.
Automatic bypass of interior zones when arming Stay.
Arming with immediate alarm on entry door violation.
Steps to disarm the system after entry.
Responding to an alarm and silencing it.
Using an ambush code for silent alarms.
Actions to take during a fire alarm.
Troubleshooting fire zone issues.
Space to draw a plan of your premises.
Factors affecting fire alarm system performance and reliability.
View status of unsecured zones.
View a list of bypassed zones.
Perform a bell test and battery check.
View system and fire status/troubles.
Enable chime for zone openings and optional watch mode.
Manually reset certain system troubles.
Reset failures in the Sensor Watch feature.
Manually start exit delay for commercial systems.
Send a test signal to the central station.
Schedule system arming after a delay.
Activate programming mode from keypad.
Installer-only function for system downloads.
Control programmed relay groups.
Features of the digital communicator.
Delay to reset system before reporting.
Notification of system arming/disarming.
Bypassing or unbypassing zones with a valid code.
Starting exit delay after central station verification.
Restarting exit delay after door re-opening.
Entering, programming, erasing, and reviewing user codes.
Delay to reset system before reporting.
Code for silent alarm when forced to disarm.
Turning the system on or off.
Arming with interior zones bypassed.
Arming with all zones protected.
Delays to exit/enter without triggering alarm.
Arming without entry delay.
Interface for controlling system functions.
Buttons for emergency alerts.
A detected problem in the system.
Personalized code for arming and disarming.
Circuits protecting specific areas of the premises.
Zone that detects intrusion.
Provides exit and entry delay for interior devices.
Zone that detects fire alarms or trouble.
Trouble when AC power is not present.
Indicates a depleted battery requiring recharge.
System unable to report to central station.
Telephone line has failed.
Keypad is not responding.
Keypad has been removed from the wall.
Expansion module cover has been removed.
Wireless transmitter tamper cover removed.
Low battery in KeyFob transmitter.
System service message, fire trouble, and bell/siren issues.
Smoke detector cleaning and keypad panic trouble.
Troubleshooting arming failure due to open zones.
Troubleshooting system troubles indicated by error codes.
Procedure for silencing and responding to a fire alarm.
To Next Page
General
