To Next Page

To Previous Page

PROGRAMMING (OPTIONAL)

Enter the User Program Mode

1. Enter your User Code, then press A to enter the Function Mode.

2. Answer NO until “ACTIVATE PROGRAM Y/N” is displayed, then press YES. “ENTER USER

CODE” will display indicating that the system is ready for User Code programming.

Programming / Reprogramming a User Code

1. Enter the digits of the user number to be programmed, followed by AA. (Example:

for User 4, enter 04 AA).

2. Enter the new User Code (up to 6 digits)

3. Press

D to save the new User Code. Duplicate Codes are not allowed; therefore a duplicate

Code entered in the LCD Window will erase when

D is pressed.

Repeat Steps 1 through 3 for each User Code to be programmed.

Erasing a User Code

1. Enter the digits of the user number to be erased followed by AA.

2. Press

G0 to erase each digit of the User Code and then press D.

• Example: Erase User 3’s 4-digit User Code:

• Press 0 3AAG0G0G0 G0 J.

User Program Mode

Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm

the system, but also to enter the User Program Mode, where you can program other User Codes, Zone Descriptions and also

set the system Time and Date. The following explains how you will use this code to program or erase additional User Codes:

ACTIVATE

PROGRAM Y/N

ENTER USER CODE

23 - -

ENTER USER CODE

- -

ENTER USER CODE

567 - -

Note: The GEM-X255 panel will display

users in 3 digits, for example:

001 4567 - -

NAPCO GEM-RP1CAe2 User Manual

Questions and Answers: