W
Wyatt SmithSep 14, 2025
How to fix synchronizing error on Napoleon BL46NTE?
- LLisa AtkinsonSep 14, 2025
To fix an error with synchronizing your Napoleon Indoor Fireplace, reset the battery holder (including switch) and remote control.
To Next PageTo Next PageHow to fix synchronizing error on Napoleon BL46NTE?
To fix an error with synchronizing your Napoleon Indoor Fireplace, reset the battery holder (including switch) and remote control.
Why won't my Napoleon Indoor Fireplace turn on or perform any functions?
If your Napoleon Indoor Fireplace won’t perform any functions, first check the breaker to ensure it’s in the “on” position. Also, if your fireplace is equipped with a battery holder (including switch), verify that the 3-position switch is in the remote position (middle).
What to do if the pilot sparks but will not light on my Napoleon Indoor Fireplace?
If the pilot on your Napoleon Indoor Fireplace sparks but doesn't light, there could be an issue with the gas supply or you might be out of propane. First, check if you are out of propane gas and fill the tank if needed. If the problem persists, contact a qualified technician to inspect the gas supply.
Why are the flames very aggressive in my Napoleon BL46NTE Indoor Fireplace?
If your Napoleon Indoor Fireplace has very aggressive flames, make sure the door is secured properly. If the problem continues, contact a qualified technician.
What to do if the pilot will not light on my Napoleon BL46NTE Indoor Fireplace and makes noise with no spark?
If the pilot of your Napoleon Indoor Fireplace won't light and makes noise without a spark at the pilot burner, and you have a remote, try reprogramming the receiver code. If the burner comes on and your fireplace has a battery holder, replace the battery holder (including switch), if applicable.
Why does my Napoleon BL46NTE burner come on when the battery holder is off?
If the battery holder (including switch) is in the “off” position and the burner comes on for your Napoleon Indoor Fireplace, it indicates that the remote control and/or battery holder is not functioning properly.
What to do if Napoleon BL46NTE Indoor Fireplace pilot won't light and makes noise?
If the pilot will not light on your Napoleon Indoor Fireplace and makes noise without a spark at the pilot burner, it could be due to no signal from the remote. Try reprogramming the receiver code. If that doesn't work, replace the battery holder (including switch), if applicable.
Why are the flames so high on my Napoleon Indoor Fireplace?
If the flames on your Napoleon Indoor Fireplace are very aggressive, make sure the door is secured properly. If the issue persists, contact a qualified technician.
What to do if my Napoleon BL46NTE won’t perform any functions?
If your Napoleon Indoor Fireplace isn't performing any functions, first check that the breaker is in the 'on' position to ensure the system has power. If equipped with a battery holder, verify that the 3-position switch is in the remote position (middle). Also, check the battery power and battery orientation in the battery holder and remote control to ensure they are operational.
What to do if my Napoleon Indoor Fireplace battery holder (including switch) or remote has low battery?
If your Napoleon Indoor Fireplace's remote control or battery holder has a low battery, replace the batteries.
General| Type | Direct Vent Gas Fireplace |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Vent Type | Direct Vent |
| Ignition | Electronic Ignition |
| Efficiency | 80% |
| Control Type | Remote Control |
| BTU | 26, 000 BTU/h |
| Venting | Direct Vent |
