To Next PageTo Next PageWhat causes white or grey film on my Napoleon GS 50 - P?
If a white or grey film is deforming on the glass, logs, or combustion chamber surfaces of your Napoleon Indoor Fireplace, it's likely due to sulphur from the fuel being deposited. Clean the glass with a recommended gas fireplace glass cleaner, ensuring you do not clean the glass when it is hot.
What to do if there's no gas at the pilot burner of my Napoleon GS 50 - P Indoor Fireplace?
If there's no gas at the pilot burner of your Napoleon Indoor Fireplace, check that the manual valve is turned on and inspect the pilot orifice for any blockage. If these steps don't resolve the issue, consider replacing the valve. If problems persist, contact the gas distributor.
Why does the pilot light go out on my Napoleon GS 50 - P Indoor Fireplace?
If the pilot light goes out on your Napoleon Indoor Fireplace, it might be because the system wasn't correctly purged. Purge the gas line with the glass door open to resolve this.
What to do if my Napoleon GS 50 - P has exhaust fumes and headaches?
If you smell exhaust fumes in the room or experience headaches when using your Napoleon Indoor Fireplace, check all the seals to ensure they are properly fitted and not damaged.
How to fix carbon deposits on the glass of my Napoleon Indoor Fireplace?
If carbon is being deposited on the glass, logs, or combustion chamber surfaces of your Napoleon Indoor Fireplace, the air shutter may be blocked. Ensure the air shutter opening is free of lint or other obstructions.
Why is the flame impinging on the logs in my Napoleon GS 50 - P Indoor Fireplace?
If the flame is impinging on the logs or combustion chamber of your Napoleon Indoor Fireplace, check that the logs are correctly positioned. Additionally, you can open the air shutter to increase the primary air. Also, verify the input rate by checking the manifold pressure and orifice size as specified by the rating plate values. Ensure the door gasketing is intact and provides a tight seal. Finally, check that both vent liners are free of holes and well sealed at all joints, and that minimum rise per foot has been adhered to for any horizontal venting.
What to do if my Napoleon GS 50 - P Indoor Fireplace has gas piping that is undersized?
If the gas piping of your Napoleon Indoor Fireplace is undersized, check if the supply piping size conforms to the code and correct any undersized piping.
What to do if my Napoleon Indoor Fireplace is out of propane gas?
If your Napoleon Indoor Fireplace is out of propane gas, fill the tank.
How to fix a blockage in the vent of my Napoleon GS 50 - P?
To fix a blockage in the vent of your Napoleon Indoor Fireplace, remove the blockage. In extremely cold conditions, ice buildup may occur on the terminal and should be removed as needed.
How to fix a sticking door on my Napoleon GS 50 - P?
If the door on your Napoleon Indoor Fireplace is sticking, lift the door from its hinges and lubricate them with high-temp dry graphite only. This issue may occur because dirt or dust adheres to the hinges, heats up, and burns, causing the sticking.
General| Brand | Napoleon |
|---|---|
| Model | GS 50 - P |
| Category | Indoor Fireplace |
| Language | English |
Details the warranty coverage for materials and workmanship.
Outlines general installation and safety guidelines.
Provides basic operational and performance information.
Instructions for cleaning and maintaining glass and plated surfaces.
Specific location and clearance details for direct vent models.
Specific location and clearance details for B-vent models.
Outlines the terms, conditions, and limitations of the warranty.
Provides essential operating and quality assurance details.
Instructions for cleaning and maintaining glass and plated surfaces.
Location and clearance requirements for GDS50 and GS50 models.
Location and clearance requirements for the GD150 insert.
Guidelines for direct vent pipe lengths and terminal placement.
Instructions for connecting the GD150 insert to a chimney.
Details for connecting the gas supply to the GD150.
Guidance on connecting the vent system for the GD150.
Instructions for installing the chimney system for the GS50.
Steps for installing the 'B' vent components.
Procedures for installing the vent adapter.
How to add sections to the venting system.
Specific gas installation steps for B-vent GS50.
Gas installation considerations for the GD150 model.
Specific gas installation steps for GDS50 direct vent.
Specific gas installation steps for GS50 B-vent.
Procedure for safely opening and closing the fireplace doors.
Instructions for installing the trivet.
Guidance on correctly positioning logs for proper flame.
How to install the variable speed switch.
Steps to install the fireplace flashing kit.
Information on mantle clearances and how to evaluate them.
How to operate and maintain the turbo burner.
General operating instructions applicable to all models.
Step-by-step guide for lighting the fireplace pilot and burner.
Procedures for safely turning off the gas supply.
Guidelines for performing maintenance on the stove.
Emergency procedures to follow if a gas leak is detected.
How to adjust the pilot burner flame size.
Guidance on adjusting air shutters for proper flame.
Information on how to order replacement parts.
List of available replacement parts and kits.
