To Next PageTo Next PageWhat to do if thermopile shorting on Napoleon Gas Heater?
If the thermopile in your Napoleon Gas Heater is shorting or has a loose connection, clean the thermopile connection to the valve, reconnect any loose connections, or replace the thermopile or valve.
What to do if my Napoleon Gas Heater is over-fired or under-fired?
If your Napoleon Gas Heater is over-fired or under-fired, check the inlet and outlet pressure readings. The inlet pressure can be checked by turning screw (A) counter-clockwise 2 or 3 turns and then placing pressure gauge tubing over the test point. Check with burner operating on 'HI'. The gauge should read 7” (minimum 4.5”) water column for natural gas or 13” (11” minimum) water column for propane. The outlet pressure can be checked the same as above using screw (B). Check with burner operating on 'HI'. Gauge should read 3.5” water column for natural gas or 10” water column for propane. After taking pressure readings, be sure to turn screws clockwise firmly to reseal. Do not over torque. Leak test with a soap and water solution.
What to do if wall switch wiring is defective on my Napoleon Gas Heater?
If the wall switch wiring is defective in your Napoleon Gas Heater, disconnect the wires from the valve. Connect a jumper wire across terminals 1 & 3; if the main burner lights, check the wires for defects and/or replace the wires.
What to do if my Napoleon Gas Heater is out of propane gas?
If your Napoleon Gas Heater is out of propane gas, fill the tank.
What to do if air shutter is blocked on my Napoleon Gas Heater?
If the air shutter on your Napoleon Gas Heater has become blocked, ensure the air shutter opening is free of lint or other obstructions.
General| Brand | Napoleon |
|---|---|
| Model | GVF36P |
| Category | Indoor Fireplace |
| Language | English |
Provides physical dimensions and diagram of the appliance.
Important safety and operational guidelines for appliance use.
Details technical specifications and operational parameters.
Explains the details found on the appliance's rating plate.
Specifies requirements for adequate air for combustion and ventilation.
Guides calculation of room volume for appliance installation safety.
Details the procedure for connecting the gas supply to the appliance.
Instructions for installing optional remote wall switch or thermostat.
Specific installation requirements for mobile homes.
Defines required distances from appliance to combustible materials.
Specifies clearances for enclosing the appliance safely.
Guidance on safe clearance for mantels based on depth.
Instructions for securing the appliance using nailing tabs.
Procedure for correctly positioning logs and grate for optimal performance.
Instructions for placing charcoal embers for realistic appearance.
Guidance on shredding and placing glowing embers for visual effect.
Instructions for installing the appliance hood component.
Step-by-step guide for fitting the louvre panels.
Instructions for applying the brand logo to the appliance.
Adjusting the air shutter for optimal flame characteristics.
Visual inspection guidelines for pilot and burner flames.
Procedure for cleaning the ODS pilot for proper operation.
Guidelines for cleaning and maintaining plated surfaces.
