Napoleon MIRAGE 730 - User Manual

Other manuals for Napoleon MIRAGE 730

Instructions64 pages

Assembly And Operating Instructions33 pages

Questions and Answers

A
Ashley BurnettNov 25, 2025
What to do if Napoleon MIRAGE 730 infrared burner flashes back?
- C
  Carla RandolphNov 25, 2025
  If the infrared burner on your Napoleon Grill flashes back, it could be due to: * Ceramic tiles overloaded with grease drippings and build-up. * Clogged ports. * Burner overheated due to inadequate ventilation (too much grill surface covered by a griddle or pan.) * Cracked ceramic tile. * Leaking gasket surrounding the ceramic tile, or a weld failure in the burner housing. To resolve this: 1. Turn the burner off and allow it to cool for at least two minutes. 2. Relight the burner and burn on high for at least five minutes or until the ceramic tiles are evenly glowing red. 3. Ensure that no more than 75% of the grill surface is covered by objects or accessories. 4. Allow the burner to cool and inspect very closely for cracks. If any cracks are found, contact your authorized...
C
Christopher Barrett MDSep 14, 2025
What to do if Napoleon MIRAGE 730 burners burn with yellow flame and smell of gas?
- V
  velasquezmeganSep 14, 2025
  A yellow flame accompanied by the smell of gas in your Napoleon Grill burners indicates a possible spider web or other debris, or improper air shutter adjustment. To fix this, thoroughly clean the burner by removing it and open the air shutter slightly according to combustion air adjustment instructions.
T
Thomas MillsSep 12, 2025
How to fix low heat/low flame on Napoleon Grill?
- R
  rebeccagonzalezSep 12, 2025
  Low heat or low flame on your Napoleon Grill, even when the valve is turned to high, can be due to a few reasons. If you're using propane, it might be an improper lighting procedure. For natural gas, the supply line might be undersized. For both types of gas, improper preheating could be the cause. Here’s how to troubleshoot: * Ensure you're following the lighting procedure carefully, with all gas grill valves in the off position when the tank valve is turned on. Turn the tank on slowly to allow pressure to equalize. * Make sure the pipe is sized according to the installation code. * Preheat the grill with both main burners on high for 10 to 15 minutes.
R
Rhonda CamposAug 28, 2025
Why Napoleon Grill burners burn yellow and smell of gas?
- C
  Christian HullAug 28, 2025
  If the burners on your Napoleon Grill are burning with a yellow flame and there's a smell of gas, it could be due to a possible spider web or other debris, or an improper air shutter adjustment. To resolve this, thoroughly clean the burner and open the air shutter slightly according to the combustion air adjustment instructions. (This must be done by a qualified gas installer.)
M
Marilyn DaviesAug 29, 2025
Why do flames lift away from Napoleon Grill burner?
- T
  Tyler PenaAug 29, 2025
  If the flames lift away from the burner on your Napoleon Grill, accompanied by the smell of gas, and possibly difficulties in lighting, it is likely due to an improper air shutter adjustment. Close the air shutter slightly according to the combustion air adjustment instructions. (This must be done by a qualified gas installer.)
A
Austin WilliamsAug 31, 2025
Why does my Napoleon Grill have excessive flare-ups and uneven heat?
- M
  Miss Kayla MccarthyAug 31, 2025
  Excessive flare-ups and uneven heat in your Napoleon Grill can occur due to several reasons. Ensure sear plates are installed correctly with the holes facing the front and the slots at the bottom, following the assembly instructions. Improper preheating can also be a cause; preheat the grill with both main burners on high for 10 to 15 minutes. Lastly, excessive grease and ash buildup on the sear plates and in the drip pan can contribute to this issue. Clean the sear plates and drip pan regularly, and avoid lining the pan with aluminum foil. Refer to the cleaning instructions for proper maintenance.
E
eliSep 1, 2025
How to fix low heat or low flame on my Napoleon MIRAGE 730 when the valve is on high?
- A
  Albert BeckerSep 1, 2025
  If your Napoleon Grill has low heat or a low flame when the valve is turned to high, the cause could be one of several things. For propane grills, ensure you are following the correct lighting procedure, with all gas grill valves in the off position when the tank valve is turned on, and turn the tank on slowly to allow pressure to equalize. For natural gas grills, the supply line might be undersized, so the pipe must be sized according to the installation code. For both propane and natural gas grills, improper preheating could be the issue. Preheat the grill with both main burners on high for 10 to 15 minutes.
A
Amber RichardsSep 3, 2025
Why does the 'paint' appear to be peeling inside the lid of my Napoleon MIRAGE 730 Grill?
- A
  aandersonSep 3, 2025
  The 'peeling paint' inside the lid or hood of your Napoleon Grill is not a defect. The finish on the lid and hood is porcelain and will not peel. The peeling is caused by hardened grease, which dries into paint-like shards that flake off. Regular cleaning will prevent this. See the cleaning instructions for guidance.
A
Ashley HallSep 16, 2025
What causes infrared burner to flash back on Napoleon MIRAGE 730 Grill?
- J
  Jared MitchellSep 16, 2025
  An infrared burner that flashes back on your Napoleon Grill could be due to ceramic tiles overloaded with grease, clogged ports, overheating from inadequate ventilation, a cracked ceramic tile, or a leaking gasket. Here’s what to do: 1. Turn the burner off and let it cool for at least two minutes. 2. Relight the burner and let it burn on high for at least five minutes, or until the ceramic tiles are evenly glowing red. 3. Make sure that objects or accessories cover no more than 75% of the grill surface. 4. Allow burner to cool and inspect very closely for cracks.
D
David HaydenSep 12, 2025
Why is "paint" peeling inside the lid of my Napoleon MIRAGE 730 Grill?
- A
  Austin LeachSep 12, 2025
  If it appears that "paint" is peeling inside the lid or hood of your Napoleon Grill, don't worry, this is not a defect. The finish on the lid and hood is stainless steel, and will not peel. The peeling is caused by hardened grease, which dries into paint-like shards, that will flake off. Regular cleaning will prevent this.

Napoleon MIRAGE 730 Specifications

General

Type	Gas Grill
Fuel Type	Propane
Total Cooking Area	730 sq. in.
Main Burner BTU	48, 000 BTU
Number of Burners	4
Primary Burners	4
Side Burner	Yes
Side Burner BTU	12, 000 BTU
Infrared Burner	Yes
Rotisserie Burner	Yes
Material	Stainless Steel
Ignition	Electronic