2 | ni.com | NI 9220 Calibration Procedure
Software Requirements
Calibrating the NI 9220 requires the installation of NI-DAQmx 9.6 or later on the calibration
system. You can download NI-DAQmx from
ni.com/downloads. NI-DAQmx supports
LabVIEW, LabWindows
™
/CVI
™
, ANSI C, and .NET. When you install NI-DAQmx, you only
need to install support for the application software that you intend to use.
Documentation
Consult the following documents for information about the NI 9220, NI-DAQmx, and your
application software. All documents are available on
ni.com and help files install with the
software.
NI cDAQ-9174/9178 Quick Start
NI-DAQmx installation and hardware setup
NI 9220 User Guide and Specifications
NI 9220 specific information, specifications, and calibration interval
NI-DAQmx Readme
Operating system and application software support in NI-DAQmx
LabVIEW Help
LabVIEW programming concepts and reference information about NI-DAQmx
VIs and functions
NI-DAQmx C Reference Help
Reference information for NI-DAQmx C functions and NI-DAQmx C properties
NI-DAQmx .NET Help Support for Visual Studio
Reference information for NI-DAQmx .NET methods and NI-DAQmx .NET
properties, key concepts, and a C enum to .NET enum mapping table
To Next Page
Loading...
Need help?
General
