Sleep Mode (CompactRIO Only)
You can enable sleep mode for the CompactRIO system in
software. In sleep mode, the system consumes less power and
may dissipate less heat. Typically, when a system is in sleep
mode, you cannot communicate with the modules. Refer to the
Specifications section for more information about power
consumption and thermal dissipation.
Specifications
The following specifications are typical for the range -40 °C to
70 °C unless otherwise noted.
Maximum baud rate 3.6864 Mbps
Maximum module
throughput
1.28 Mbps
Maximum cable length 1.2 km (4,000 ft)
NI 9871 Getting Started Guide | © National Instruments | 15
To Next Page
Loading...
