National Instruments 5761R User Manual

NI 5761R User Guide and Specifications
The NI 5761 is a 250 MS/s analog input adapter module designed to work in conjunction with your
NI FlexRIO™ FPGA module. This document contains signal information and specifications for the
NI 5761R, which is comprised of an NI FlexRIO FPGA module and the NI 5761. This document also
contains tutorial sections that demonstrate how to acquire data using a LabVIEW FPGA example VI
and how to create and run your own LabVIEW project with the NI 5761R.
Contents
Front Panel and Connector Pinouts ..................................................................................................... 2
Block Diagram ..................................................................................................................................... 4
NI 5761 Component-Level Intellectual Property (CLIP) .................................................................... 5
Cables................................................................................................................................................... 6
Clocking............................................................................................................................................... 7
Using Your NI 5761R with a LabVIEW FPGA Example VI.............................................................. 7
Creating a LabVIEW Project and Run a VI on an FPGA Target ........................................................ 9
How to Use Your NI FlexRIO Documentation Set ............................................................................. 12
Specifications....................................................................................................................................... 13
Where to Go for Support ..................................................................................................................... 24
Note Before configuring your NI 5761R, you must install the appropriate software and hardware.
Refer to the NI FlexRIO FPGA Module Installation Guide and Specifications for installation
instructions. Figure 1 shows an example of a properly connected NI FlexRIO device.
Figure 1. NI FlexRIO Device
NI FlexRIO
Adapter Module
+ = NI FlexRIO Device
NI FlexRIO
FPGA Module

National Instruments 5761R Specifications

General

Brand	National Instruments
Model	5761R
Category	Control Unit
Language	English

Summary

Front Panel and Connector Pinouts

Front Panel Overview

Provides an overview of the NI 5761 front panel layout and connectors.

AUX I/O Connector Pin Assignments

Details the pin assignments for the NI 5761's Micro-D AUX I/O connector.

Block Diagram

NI 5761 Component-Level Intellectual Property (CLIP)

Cables

Clocking

Using Your NI 5761R with a LabVIEW FPGA Example VI

Creating a LabVIEW Project and Run a VI on an FPGA Target

Creating a LabVIEW Project

Guides on creating a new LabVIEW project for the NI 5761.

Creating the FPGA Target VI

Instructions for setting up the FPGA target and configuring clocks and CLIPs.

Creating the Host VI

Details on developing the host VI for communication with the FPGA target.

Running the Host VI

Procedures for running the host VI and acquiring data from the device.

How to Use Your NI FlexRIO Documentation Set

Specifications

Analog Input Specifications

Covers general characteristics, ADC details, and AC/DC coupled input specifications.

Spectral Performance Measurements

Presents AC/DC coupled spectral performance, bandwidth, and isolation measurements.

Analog Input Phase Noise

Details the phase noise performance of the analog input channels.

Clock and Trigger Specifications

Details specifications for internal/external sample clocks and reference clocks, plus trigger inputs.

PFI and EEPROM Specifications

Covers PFI input levels, general characteristics, and the EEPROM map details.

Where to Go for Support