© National Instruments | I-1
Index
Symbols
<20 MHz source mode, 5-40
Numerics
10/100 LED, 1-28
10/100/1000 LED, 1-28
80 MHz source mode, 5-39
A
accessories, 1-31
acquisitions, digital waveform, 4-2
ACTIVE LED, 1-26
analog input
getting started with applications in
software, 2-7
timing signals, 2-2
triggering, 2-1
analog input signals
AI Convert Clock behavior, 2-3
AI Pause Trigger, 2-7
AI Reference Trigger, 2-5
AI Sample Clock, 2-2
AI Sample Clock Timebase, 2-2
AI Start Trigger, 2-5
analog output
data generation methods, 3-1
getting started with applications in
software, 3-6
glitches on the output signal, 3-6
timing signals, 3-3
triggering, 3-3
analog output signals
AO Pause Trigger, 3-5
AO Sample Clock, 3-3
AO Sample Clock Timebase, 3-4
AO Start Trigger, 3-4
ANSI C documentation, B-3
antenna, 1-30
applications
counter input, 5-3
counter output, 5-24
edge counting, 5-3
arm start trigger, 5-38
B
buffered
edge counting, 5-4
hardware-timed generations
analog output, 3-2
digital output, 4-9
position measurement, 5-21
two-signal edge-separation
measurement, 5-22
C
C Series I/O module
installing, 1-7
parallel versus serial DIO, 1-33
uninstalling, 1-31
C Series module, 1-32
specifications, B-2
cabling, 1-31
cascading counters, 5-38
cDAQ chassis
default settings, 1-30
features, 1-26
installation and configuration, 1-5
mounting, 1-16
NI cDAQ-9181, 1-1
NI cDAQ-9184, 1-2
NI cDAQ-9188, 1-2
NI cDAQ-9191, 1-1
regulatory information, A-1
rebooting, 1-30
reserving in MAX, 1-15
specifications, B-1
troubleshooting connectivity, 1-14
uninstalling, 1-31
unpacking, 1-5
using, 1-32
cDAQ module interface, 1-33
channel Z behavior, 5-20
chassis grounding screw, 1-26
To Next Page
Loading...
