Windows 7
For information about driver installation on Windows 7, go to ni.com/info and enter the Info
Code raidsupport for instructions on where to download the drivers for your device.
Windows 10
No driver is necessary to configure the drives. The Standard Microsoft NVME driver is pre-
installed in Windows 10.
RAID Creation
To configure the software RAID on the PXIe-8267, complete the following steps.
Note Back up your data before you configure the software RAID.
Note In the following steps, the disk drive capacities in the images are examples.
You may see different capacities depending on your disk drives.
1. Right-click My Computer and click Manage.
2. Click Disk Management in the left window. You should see four disk drives of the same
size in basic mode. If the disks do not have a status of Unallocated, right-click any disk
and select Delete Partition.
3. Right-click any disk and select New Striped Volume, then click Next.
PXIe-8267 Getting Started Guide | © National Instruments | 5
To Next Page
Loading...
Need help?
General
