© National Instruments | 3-5
RMX Programmable Power Supplies User Manual
About the J2 Connector
The J2 connector can be split into two parts: the socket and the detachable plug. The plug is
attached to the J2 socket when the RMX programmable power supply ships from the factory.
If you damage or lose the detachable plug, contact National Instruments for a replacement.
To minimize the influence of noise, NI recommends using shielded twisted pair wires to make
connections.
Figure 3-6. J2 Connector
J2 connector
Strip 7 mm (0.28 inches) of the cable
covering, and then insert the cable here.
Use this screw to fix the wires in place
so that they do not come loose.
To Next Page
Loading...
