National Instruments VirtualBench - Documentation; Test Equipment

NI VirtualBench Calibration Procedure | © National Instruments | 3
Documentation
Consult the following documents for information about the NI VirtualBench and your application
software. All documents are available on ni.com and help files install with the software.
Test Equipment
Table 2 lists all recommended equipment for the performance verification and adjustment
procedures for all VirtualBench instruments. If the recommended equipment is not available,
select a substitute using the requirements listed in the table.
NI VirtualBench VB-8012 Quick Start or
NI VirtualBench VB-8034/8054 Quick Start
Contains: NI VirtualBench hardware installation, software launching
NI VirtualBench VB-8012 Specifications, NI VirtualBench VB-8034
Specifications, or NI VirtualBench VB-8054 Specifications
Contains: specifications and calibration interval for your VirtualBench
NI VirtualBench VI Reference Help
Contains: LabVIEW programming concepts and reference information about
NI VirtualBench VIs and functions
Table 2. VirtualBench Calibration Recommended Equipment
Equipment
Recommended
Model
Instrument
Calibration
Minimum
Requirements
Multifunction
calibrator
Fluke
5700A/5720A/5730A
Digital Multimeter
(DMM) Calibration
Procedure
Must be calibrated
within the last year.
Low thermal
electromotive
force (EMF)
copper cable
Fluke 5440A-7002 Digital Multimeter
(DMM) Calibration
Procedure
Low thermal
electromotive force
(EMF) copper cable
with 4 mm banana
connectors.
Amplifier Fluke 5725A Digital Multimeter
(DMM) Calibration
Procedure
Must be calibrated
within the last year.
Shielded interface
cable for the
amplifier
Fluke 842901 Digital Multimeter
(DMM) Calibration
Procedure
—