3.3. Connecting Monitors for DJ Booth
To connect your monitor speakers or a second power amplifier to the TRAKTOR KONTROL S3 for
use in a DJ booth:
• Connect the BOOTH OUT outputs on the rear panel of the TRAKTOR KONTROL S3 to the
inputs of your monitoring system using appropriate cables.
3.4. Connecting Headphones
To connect headphones to the TRAKTOR KONTROL S3:
• Connect your headphones to the PHONES OUT socket on the front panel of the TRAKTOR
KONTROL S3 using a 1/4" or a 1/8" connector.
3.5. Connecting to the Power Supply
To connect the Power supply to the TRAKTOR KONTROL S3:
1. Connect the device end of the power supply cable to the power socket on the rear panel of
your S3.
2. Connect the power supply unit to a power outlet.
3.6. Final Preparation
After successfully setting up the TRAKTOR KONTROL S3 system, you need to complete the final
steps before you can start using your S3. First, switch on your devices and then configure the
TRAKTOR software to be used with your S3.
Switching on Devices and Starting TRAKTOR
You can now switch on the devices. We recommended that you follow the order in the instructions
below:
1. On your S3 turn down the volume controls to the minimum position by using the MASTER
knob, the BOOTH knob, and the VOL knob.
2. Switch on your amplification system.
3. Switch on your computer.
4. Switch on your S3.
5. Start TRAKTOR by double-clicking the TRAKTOR application icon on your desktop.
The TRAKTOR software opens.
Importing Data from Your Previous TRAKTOR Version
When you start TRAKTOR for the first time, TRAKTOR checks if a previous version of TRAKTOR
is installed on your system. In this case, TRAKTOR asks if you want to import your previous data
from the existing user content into a new folder in your user folder. Your previous data will not be
changed if you import it to the new default folder.
If you want to import data from your previous TRAKTOR installation:
Setting up TRAKTOR KONTROL S3
4
To Next Page
Loading...
Need help?
General
