natus ALGO 5 - Page 29

ALGO® 5 Newborn Hearing Screener Service Manual
P/N 000976 Rev.A
29
• The fuses should be installed as illustrated in below. There are 2 fuses -- one on
each side (refer to FIGURE 23).
FIGURE 23: Fuse holder
If the fuses are faulty, replace them with the following type of fuses:
115V:
6.3A,Slo-blw,5x20mm,250V
Natus Part number:000801
Suggested manufacturer: Schurter (P/N 0034.3125 )
230V:
3.15A,Slo-blw,5x20mm,250V
Natus Part number:000800
Suggested manufacturer: Schurter (P/N 0034.3122 )
Reverse the above steps to complete the fuse replacement, making sure that the
voltage selection is the same as it was before the fuses were replaced.