What to do if the natus Amplifier power on indicator is not lit?
If the power on indicator is not lit, check that the AC power cord is connected to a wall outlet and to the power pack. Ensure all power supply connections are secure. You may also try switching to an alternate power source. The power supply itself may also be malfunctioning.
Why natus Amplifier power pack becomes hot?
If the power pack becomes hot, it may be defective. Immediately disconnect the power pack from the power supply, replace it, and remove the defective power pack from further service.
What to do if natus Amplifier power pack will not go into charge mode?
If the power pack won't go into charge mode, it might already be fully charged, requiring no action. Alternatively, the power pack may not be properly connected to the power supply; in this case, remove the power supply plug and reconnect it to the power pack connector. A defective power pack or a power pack that is too hot or cold can also cause this issue. If the power pack is too hot or cold, allow it to return to room temperature.
What to do if natus Amplifier shows an error message (amber light flashing)?
If you see an error message (amber light flashing), it could be due to over discharge of the power pack, in which case you should leave the power pack connected to the power supply and allow it to recover. It could also indicate a charger fault condition; try disconnecting the power pack from the power supply and reconnecting it. Finally, a defective power pack can cause this error, and you would need to replace it.
What to do if the natus Xltek Trex HD power pack becomes hot?
If the power pack becomes hot, it may be defective. Immediately disconnect the power pack from the power supply, replace it, and remove it from further use.
What to do if natus Xltek Trex HD Medical Equipment power pack will not go into charge mode?
There are several reasons why the power pack might not be charging: * The power pack may already be fully charged, in which case no action is needed. * The power pack might not be properly connected to the power supply. Try removing the power supply plug and reconnecting it to the power pack connector. * The power pack may be defective, requiring replacement. * The power pack may be too hot or cold. Allow the power pack to return to room temperature.
What to do if natus Xltek Trex HD shows an error message (amber light flashing)?
An amber light flashing indicates an error. This could be due to: * Over discharge of power pack: Leave the power pack connected to the power supply and allow it to recover. * Charger Fault: Disconnect the power pack from the power supply and reconnect it. * Defective power pack: Replace the power pack.
How to fix if the natus Medical Equipment power on indicator is not lit?
If the power indicator light is off, it could be due to: * The AC power cord is not connected to a wall outlet. Check all power supply connections and switch to an alternate power source. * Power cord is not connected to the power pack. * Power supply not functioning.
General| Manufacturer | Natus Medical Incorporated |
|---|---|
| Type | EEG |
| Common Mode Rejection Ratio | > 110 dB |
| Impedance Check | Yes |
| Device Type | Ambulatory EEG System |
| Sampling Rate | Up to 2000 Hz per channel |
| Resolution | 24 bits |
| Noise | < 1.0 µV RMS |
| High Pass Filter | 0.1 Hz |
| Notch Filter | 50 Hz or 60 Hz |
| Connectivity | USB |
| Wireless Communication | Optional |
| Video | Optional |
| Power Source | Rechargeable battery |
| Design | Portable, lightweight |
To Next Page
