NV30/NV40 Operations and Maintenance Manual Non-standard maintenance
Issue 3.3 2014-12-10 Page 4-7
6. Remove the old output connector cup, noting it is secured to the output power probe with
an M10 hex bolt.
7. Install the new output connector cup using an M10 hex bolt.
8. Assemble the new spacer plates and output plate together using hardware retained in Step 5.
Install the plates on top of the transmitter and secure to the output power probe using
hardware retained in Step 5.
9. Install the new coaxial RF feed cable on the new RF output connector using the 3/8 or 5/16
studs on the stud plate.
To Next Page
Loading...
